BMW E90 Crankshaft Sensor Replacement. Jump to Photos. 122 Comments. Project Time: 3 hours. Tab: $130. Talent. Tools: Set of sockets, 5mm Allen bit, flathead screwdriver. Parts Required: Crankshaft position sensor, sealing O-ring, crankshaft sensor fastener. Performance Gain: Car will start and run well.
I own a BMW e90 2006 model and of late am experiencing a rough idle, sometimes the engine going off and jerking on taking off but especially on reversing.service is up to date, I have replaced the air mass sensor, oil separator and fuel pump but the problem is still there. I've got 2005 E90 330i n52b30 engine. On cold start car starts nicely, but almost immediately there is uneven idle. Like 50 rpm up and down, but needle is visibly moving. On warm start the whole car shakes for few secs 2-3secs and again uneven idle.What engine is in 2008 BMW E90 3 Series 330i? The 2008 BMW E90 3 Series 330i has a Inline 6, Petrol engine with 2996 cm3 / 182.8 cu-in capacity. How many horsepower (hp) does a 2008 BMW E90 3 Series 330i have?
HI. BMW e90 / 330i model 2010 , European version. Car on cold start has rough idle for some seconds before RPM goes back to stable mode, also car has hesitation on low RPM , or on acceleration. I cleaned the throttle body, changed plugs, tested coils, no solution so thought to disconnect MAF sensor cable before starting the car after car rest zaLwI93.